How to Complete the CARB Clean Truck Check: A Step-by-Step Guide - DPF Discounter

How to Complete the CARB Clean Truck Check: A Step-by-Step Guide

Published on

|

Time to read 2 min

Introduction

The California Air Resources Board (CARB) requires certain diesel vehicles operating in the state to undergo regular emissions testing as part of the Clean Truck Check program. If you're a truck owner or fleet manager looking to get compliant, this guide will walk you through the process of completing the CARB Clean Truck Check efficiently and correctly.

CARB

Step 1: Determine If Your Vehicle Needs the Clean Truck Check

The Clean Truck Check applies to most diesel-powered vehicles over 14,000 pounds that operate in California. This includes in-state and out-of-state vehicles that enter California. Check CARB’s official website or consult an emissions testing specialist to verify your vehicle’s requirements.

Step 2: Register Your Vehicle in the Clean Truck Check System

To participate in the program, you must register your vehicle on CARB’s Clean Truck Check portal . This involves:

  • Providing your vehicle’s details, including VIN and engine information.
  • Paying any applicable registration fees.
  • Setting up an account to track compliance and testing history.

Step 3: Schedule a Clean Truck Check appointment

To maintain compliance, you need to complete a periodic emissions test. Find a CARB-compliant testing facility, such as Diesel Emissions Specialists in Canton, Ohio , to conduct the test if your vehicle is in the region. Here are what you should expect: assistance to ensure proper setup.

  • Connect CARB-approved testing device to your truck’s diagnostic port. It could be your J1939 green connector, J1939 black connector, or J1979 connector
  • Use CARB-approved software to run the Clean Truck Check. This process only takes a few minutes.
  • Submit the test data to CARB.
  • Both tester and driver can log into CARB’s Clean Truck Check portal to check the test result in 5-15 minutes.
diagnostic connectors

Step 4: Address Any Issues If Your Vehicle Fails

If your vehicle does not pass the CARB’s Clean Truck Check test, you will need to make necessary repairs and retest before the compliance deadline. Common reasons for failure include:

  • Malfunctioning Diesel Particulate Filters (DPFs).
  • Excessive opacity levels.
  • Faulty engine sensors affecting emissions.
aftertreatment system

Step 5: Keep Up with Ongoing Compliance

CARB requires regular emissions testing, so be sure to mark your calendar for future testing deadlines. Staying compliant helps you avoid fines and potential restrictions on operating in California.

Get Your CARB Clean Truck Check Done Today!

If you need a reliable emissions test, Diesel Emissions Specialists in Canton, Ohio offers CARB-compliant testing to ensure your vehicle meets state regulations. Contact us today to schedule your test and stay on the road with confidence!


For more details or to book an appointment, call 330-573-5396 or visit  DPF Discounter website.

Related Posts